Making a custom bottom Shelf for Traeger Ironwood 650 & 850

[MagOutdoors]

Hi, I'm making custom wooden shelves for various Traeger Pro grills and I need some measurements from people that has a Traeger Ironwood 650 and 850. They will fit on the bottom lip of the leg supports (see attached). Could people that have either a Traeger Ironwood 650 or 850 take some measurements for me so I will be able to custom make and offer these through Etsy? I've included some pictures of how to measure the distance between the leg supports, as well as, the prototype shelf I made for a Pro 22. I want to offer shelves that will fit all Traegers models. Thanks for your help!

 

[BobbyQ]

Pretty easy job. Check out this thread.

Ironwood 885 bottom shelf

I put together a bottom shelf on my IW 885. Made out of a couple of cedar boards. I sealed them with spar urethane.

www.traegerforum.com

On the 650 you can't fit 4 1X4's. I needed to rip an inch off one to make it fit. Didn't bother to brace the bottom as once you get the side panels back in place it isn't going anywhere.

 

[MagOutdoors]

Pretty easy job. Check out this thread.

Ironwood 885 bottom shelf

I put together a bottom shelf on my IW 885. Made out of a couple of cedar boards. I sealed them with spar urethane.

www.traegerforum.com

On the 650 you can't fit 4 1X4's. I needed to rip an inch off one to make it fit. Didn't bother to brace the bottom as once you get the side panels back in place it isn't going anywhere.

Thanks BobbyQ!

 

[BobbyQ]

Thanks BobbyQ!

Good luck. Welcome to the forum.