kingjayhall
New member
Hello, All,
I've had my Pro34 since 2020 and until recently, it has worked flawlessly. A few months ago, it started taking longer and longer to ignite and occasionally I would get the Ler code, so I would turn it off and back on, and eventually it would ignite. Then it stopped completely. I purchased a hot rod and porcelain fire pot, installed it and no change. Next I bought a new bag of pellets, and still nothing. Since then I've replaced the induction fan, the rtd probe twice, the auger motor, new controller from Traeger, and two more hot rods. Still nothing. I can't come up with anything else to do besides kick it to the curb! Please assist if anyone has any ideas.
Oh, I've tried the hot rod at 1/8", 1/4", and 5/8" stick out and nothing will get it to ignite like it should, and always had before. This morning, after installing another new hot rod, and two ler codes later, I got it to ignite. By then, there were so many pellets in the pot, it raced to over 550 degrees while being set at 250. The pic is hard to read but it's at 565.
Please help.
I've had my Pro34 since 2020 and until recently, it has worked flawlessly. A few months ago, it started taking longer and longer to ignite and occasionally I would get the Ler code, so I would turn it off and back on, and eventually it would ignite. Then it stopped completely. I purchased a hot rod and porcelain fire pot, installed it and no change. Next I bought a new bag of pellets, and still nothing. Since then I've replaced the induction fan, the rtd probe twice, the auger motor, new controller from Traeger, and two more hot rods. Still nothing. I can't come up with anything else to do besides kick it to the curb! Please assist if anyone has any ideas.
Oh, I've tried the hot rod at 1/8", 1/4", and 5/8" stick out and nothing will get it to ignite like it should, and always had before. This morning, after installing another new hot rod, and two ler codes later, I got it to ignite. By then, there were so many pellets in the pot, it raced to over 550 degrees while being set at 250. The pic is hard to read but it's at 565.
Please help.
