Controller install question

[annewaldron]

Got a replacement controller and read the instrux. No mention is made of the taped-on label and the affixed spare fuse. I assume I’m OK to just leave them in place? Leaving the fuse in place makes sense, I guess I’m more curious about that taped label...

 

[annewaldron]

Answered my own question when I removed the other control panel: leave them be, which is why it doesn’t mention anything about them in the installation instructions

To those of you installing new control panels, at first I was irritated because all of the wires were zip-tied so snuggly that I had to remove the bottom panel to cut the ties to access the molex connectors (installation instructions don’t mention this, so I assumed a very type-A assembler put mine together). But then I realized this was done because it could be very easy for loose wiring to impede the fan in the auger motor, which would not be good. So I’ll be re-zip-tying everything (I’ll never get it as good as they had it, but hopefully good enough!)

Also, I made sure it WORKED before putting everything back together 100%