Search results

What's your cooking temperature? Like JD said above, you need to keep the temps as low as possible to get visible smoke, usually 170-195 for an hour then turn up as desired. Sometimes it's a struggle to keep it low especially if it's hot outside. I have even propped the door open a little bit...

Try raising the chimney cap a couple of turns. Increased exhaust might help.

I wanted a constant 165* last weekend for smoking some ribeyes and the lowest it would go is 200*. If I cracked the door open just a little bit it would go down and produce more smoke. Next time I'll play with the stack cap elevation to see it that helps.

I've been doing fine with the 575 so far. For searing I use my charcoal grill. The Traeger now goes to 500* with the new firmware but the charcoal sear adds a flavor of it's own and sears instantly. I still haven't bought the folding front shelf. Just stubborn I guess.

Calibrate the meat probe with boiling water and don't forget to adjust for your altitude if that applies. 212* is a lot closer than ice water.

It's a variable speed motor so it might be running at slow speed and you don't hear it. Mine does this as well.

The new software update allows it to go to 500*.

Lower the vent cap to half that and try again. If that doesn't work, lower it more. It should be able to go to 500* in about 10 minutes.

I'm jealous. That's what I should have bought.

If you want a deal go to Costco and look at the Silverton. Comes with shelves, cover, pellets and lower cabinet for less than the bare grill. I think they have the 620 and 810 sizes, $799 and $1,350 on line and less in the store. The 810 has super smoke but I don't miss it with my 570, I just...

If you have melted plastic on the thermocouple, just scrape it off under heat. I seriously doubt it would be damaged. Are you using the meat probe? Did you calibrate the meat probe? Are you checking internal temperature of the meat with a reliable instant read thermometer like Thermopen or...

That doesn't sound right. The auger should stop feeding pellets if the thermostat reads higher than the set temperature but it does take a few minutes to bun off the excess pellets. I'm not sure how the blower is programmed but it only furnishes combustion air.

Mine overshoots every time, no big deal. During ignition it dumps pellets in the firepot and it takes a while to ignite, then they all ignite. Just open the lid and let it cool to desired temp. It will level out.

ThermoPro TP-19. Very accurate and fast readout. Only cost ~$30. https://www.amazon.com/gp/product/B07R18W3W1/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1

The last duck I’ve attempted to cook was a total disaster. I hope they are domestics, mine were taken over a farm pond and they smelled like sewage. I haven’t hunted duck since.

I like to smoke the ribeye at 180* until Internal temp reaches 110 then drop them on a hot charcoal grill to sear. I always wrap with bacon so the charcoal flames up and sears quickly. Watch the internal temps while grilling or it will overcook quickly.

That sucks. When I started my smoke yesterday it took an unusually long time to ignite. I got out the old propane torch and started the pellets manually. It’s been a month since I’ve used the grill so if it does this again, I’ll be looking for answers like you. The auger did keep dumping pellets...

No fires but at 500* it did burn off some of the grease that dripped on the drain pan. Just smoke though. Before lowering the stack cover, I couldn't break 350* during the curing process.

Craigers, Your 575 should now go to 500* with the new firmware. I had to lower the chimney vent but mine was stellar yeterday. It rocketed from 225* to over 500* in less than 5 minutes to reverse sear a prime rib. Perfect crust outside and medium rare inside.

If I put the smoke stack cover 1" above the stack, I wouldn't come near 400*. That's where it was from the factory. I put mine roughly 1/8" above the stack and haven't had a problem since. Yesterday I smoked a prime rib at three temperatures: 180, 225 and 500* to reverse sear. It shot to 500 in...